The Origami Forum

I am having some trouble with treemaker. I want to design a symmetric cp, and I even use the symmetry option, but treemaker still makes the cp completely unsymmetric. Can somebody help me? Thanks!
-Justin

You must make things symmetric to each other also. In other words these two flaps should be paired around the symmetry line, this one should be on the symmetry line, etc. These are called conditions. If you select symmetry but do not set any conditions for symmetry, there will be none.

I did that too but it still failed

Not sure how to help you then, have you done all the tutorials?

cowburger13 wrote:I am having some trouble with treemaker. I want to design a symmetric cp, and I even use the symmetry option, but treemaker still makes the cp completely unsymmetric. Can somebody help me? Thanks!
-Justin

Firstly, there are plenty of threads about TreeMaker. A lot are similar to this one; asking for help with a problem. It seems like it would help others more to have all problems and solutions in one place, so that they can have their questions answered more readily.

This seems to be the best place for adding new comments and questions, etc. so I shall reply to your question there.

Alright, thanks