The Origami Forum

the model for this months challenge is the first crease pattern i have ever folded; highland ram by Dr. Stephen 'O' Hanlon- http://www.fishgoth.com/origami/diagrams/cp_ram.pdf

rules: must be from one square sheet of paper (otherwise you wouldn't be following the cp) and mc is allowed for shaping. good luck to everyone!

Cool, I'll try my best. I failed the last 2 cp challenges... A picture of the completed model would really help! Be good to see what it's supposed to look like

thanks!

any clues on the landmarks that form the rectangle horn-horn-rearleg-rearleg?

All I'll say is that a kite base would help with references. Try getting a ruler and continuing lines to see where they go, that's how I find cp references

Am I allowed to enter?

PS - Kite fold to find reference point, and then it is essentially a fish base with a large strip graft in the middle, and a Montroll style 'wing' base at one end.

Fishgoth: sure, you can enter. As long as the model is folded this month.

You are aware that I'm the original creator of that model?

Regards,
Dr Stephen O'Hanlon

Of course I know!

here's my try

mine turned out a lot thinner (I guess it does not need the thick fur in summer )

nice try jeko! i will wait for 3 more hours, then june should be ended all over the world. hopefully there are more entries to come, since fishgoth and langko mentioned they might try...

well... winner should be clear, congratulations to jeko for finishing this model!
all in all, you got the essence of the model, the colour changes fit. The neck seems way longer than in the original. Apart from that my only point of criticism is the paper, you used... The colours dont seem to fit the model. Anyway, congratulations for a good fold, and being the winner of this month... Hopefully, you will be able to judge more entries at the end of next month... i will create the new topic later today

tschobigami, thanks a lot for the comments!
Now that I look at it again, the long neck actually makes it look more like a goat than a ram...