origami phoenix by hoang trung thanh

philipinorigami101 · Post by **philipinorigami101** » July 20th, 2010, 7:32 pm

i need some help on this new satoshi's mod of the phoenix:
http://origami.artists.free.fr/Hoangtru ... hoenix.htm
it looks more simpler than satoshi's cp so i thought i give it a go, but i don't know where to start with, so if anyone can help me...

bethnor · Post by **bethnor** » July 20th, 2010, 9:44 pm

i don't do crease patterns.

that said, at least in this one, the divisions and landmarks are all clearly set out for you.

JumPurge · Post by **JumPurge** » July 21st, 2010, 1:53 am

It looks like you just do this*, close sink, and then fiddle around for the head, wings, and feet.

*

Since it's so similar to Satoshi's, you might want to look into his phoenix too

philipinorigami101 · Post by **philipinorigami101** » July 23rd, 2010, 5:06 pm

thx JumPurge, now, i only nead help on the head, any suggestions?

JumPurge · Post by **JumPurge** » July 23rd, 2010, 7:07 pm

Well, it looks like it's a crane base, but with half of it pleated instead of petal folded.

maddoghoek100 · Post by **maddoghoek100** » July 26th, 2010, 1:21 am

I made this model after I saw this thread and got a nice result, not to difficult but with a strong result, i could not figure out the asymmetry in the head and the feet, so I just made them symmetric.

jewishdan18 · Post by **jewishdan18** » July 26th, 2010, 12:19 pm

maddoghoek100 wrote:I made this model after I saw this thread and got a nice result, not to difficult but with a strong result, i could not figure out the asymmetry in the head and the feet, so I just made them symmetric.

I'm pretty sure the bottom right half is a narrowed version of the upper left.