Page 1 of 1
stag beetle BP - robert lang
Posted: May 6th, 2012, 4:51 pm
by GeorgianFolder
hi
i am folding stag beetle by robert lang and can't collapse this part , please help me
Re: stag beetle BP - robert lang
Posted: May 6th, 2012, 7:01 pm
by Froy
That point is a sink. Fold it as a normal point and then sink it. (you have to open the model and refold it as a sink not just sink it)
Re: stag beetle BP - robert lang
Posted: May 6th, 2012, 8:44 pm
by GeorgianFolder
i can't get it
can you show me ? i test fold only that point and i can't sink
Re: stag beetle BP - robert lang
Posted: May 12th, 2012, 6:41 am
by Baltorigamist
I don't see any sinks involved. The 2nd-lowest point forms the head, I'm guessing, and the uppermost flaps (on the edge) are the secondary mouthparts. Just pleat between them and Elias-stretch.
Re: stag beetle BP - robert lang
Posted: June 1st, 2012, 1:46 pm
by Spliffonaut
Froy is right. its a sink there.
1: Is unused paper and need to be a sink, so that u can see the jaw thats hidden under..
2: this is the Jaw
Here u can see the cp area collapsed.
Like Froy sayed u need to open up the model to do this sink, u need to reverse all the folds inside the square i made here on this pic. this can be hard if u dont have any clue on how to to it.
see this video:
http://www.youtube.com/watch?v=7-gb-K-cBu8
This is my fold..