Page 1 of 1
Ankylosaurus Help (Ronald Koh)
Posted: November 22nd, 2012, 5:11 pm
by Buu11235
http://dev.origami.com/images_pdf/ankylosaurus.pdf
This is the diagram I am using, and I am having trouble with step 21/22.
I don't see where to do the 1/96 crimp. Any help is much appreciated.
Re: Ankylosaurus Help (Ronald Koh)
Posted: November 22nd, 2012, 5:30 pm
by phillipcurl
that's not a mountain fold, it is an open sink. check that you are folding below where the right triangle's hypotenuse ends by about 1.5 blocks. make sure you precrease the angle bisector, as that is the fold you will be sinking on.
Re: Ankylosaurus Help (Ronald Koh)
Posted: November 22nd, 2012, 6:36 pm
by Buu11235
phillipcurl wrote:that's not a mountain fold, it is an open sink. check that you are folding below where the right triangle's hypotenuse ends by about 1.5 blocks. make sure you precrease the angle bisector, as that is the fold you will be sinking on.
Yeah, despite a half hour trying to refold it, it's the 2 minutes after i post that i figure out the right way to do it. Some how the sink was covering that corner.
Though now it's the question of where/what to crimp in 21, and how to sink the top half of 23 (unless the diagram isn't showing all of the folds)