Page 1 of 1
Marc Kirschenbaum - Bee
Posted: April 8th, 2009, 7:32 pm
by alma
hey, i'm a bit of a newbie, but i've been doing Marc Kirschenbaum's bee creation, and i'm stuck on step 30! no doubt i'll get stuck on a lot more steps to come, but if anyone could help me out, that would be AMAZING xxx
Posted: April 8th, 2009, 7:40 pm
by Ben385
This manoevre is called a color change, because it changes the color of the surface flaps. You have to grap the layer just behind the front, and then try to bring it around. You will have to 'pop' the corner in to allow this to happen. Just use your finger and applie a little pressure.
Sorry, it's hard to explain in words, but my camera is still not working.
Posted: April 8th, 2009, 7:42 pm
by alma
thankyou so much! i thought about that, but i guess i was scared in case it ripped or something
thanks again xxx
Posted: April 8th, 2009, 8:04 pm
by Ben385
You're welcome!
