Page 1 of 1
origami phoenix by hoang trung thanh
Posted: July 20th, 2010, 7:32 pm
by philipinorigami101
i need some help on this new satoshi's mod of the phoenix:
http://origami.artists.free.fr/Hoangtru ... hoenix.htm
it looks more simpler than satoshi's cp so i thought i give it a go, but i don't know where to start with, so if anyone can help me...
Posted: July 20th, 2010, 9:44 pm
by bethnor
i don't do crease patterns.
that said, at least in this one, the divisions and landmarks are all clearly set out for you.
Posted: July 21st, 2010, 1:53 am
by JumPurge
It looks like you just do this*, close sink, and then fiddle around for the head, wings, and feet.
*
Since it's so similar to Satoshi's, you might want to look into his phoenix too
Posted: July 23rd, 2010, 5:06 pm
by philipinorigami101
thx JumPurge, now, i only nead help on the head, any suggestions?
Posted: July 23rd, 2010, 7:07 pm
by JumPurge
Well, it looks like it's a crane base, but with half of it pleated instead of petal folded.
Posted: July 26th, 2010, 1:21 am
by maddoghoek100
I made this model after I saw this thread and got a nice result, not to difficult but with a strong result, i could not figure out the asymmetry in the head and the feet, so I just made them symmetric.
Posted: July 26th, 2010, 12:19 pm
by jewishdan18
maddoghoek100 wrote:I made this model after I saw this thread and got a nice result, not to difficult but with a strong result, i could not figure out the asymmetry in the head and the feet, so I just made them symmetric.
I'm pretty sure the bottom right half is a narrowed version of the upper left.