Help with Demonio by Fernando Gilgado
Forum rules
READ: The Origami Forum Rules & Regulations
READ: The Origami Forum Rules & Regulations
Help with Demonio by Fernando Gilgado
I am in need of help with step 46 of Fernando Gilgado's Demonio. I can't end up with the same result shown in step 47. Pictures would be nice 
- Daydreamer
- Moderator
- Posts: 1423
- Joined: October 28th, 2005, 2:53 pm
- Location: Vienna, Austria
- Contact:
My guess is that you are thinking too difficult for this step. You don't have to crimp or reversefold anything. Just fold the whole flap to the left along the valley fold line and then fold it back to the right along the mountain fold line.
If this doesn't work you might have done something wrong in an earlier step.
If this doesn't work you might have done something wrong in an earlier step.
So long and keep folding ^_^
Gerwin
Gerwin
Step 60?
Hey, I was wondering if you might advise me on step 60. I can't seem to make it work. Are the valley folds shown the only creases made, or do I end up making any other creases? If so, where? Could I pre-crease anything to make the step easier?
Also, in step 59, I just inside reverse folded a small bit of paper. What happens to that in step 60? Does it show at all at the end of the step, or is it hidden? Thanks for your help!
Also, in step 59, I just inside reverse folded a small bit of paper. What happens to that in step 60? Does it show at all at the end of the step, or is it hidden? Thanks for your help!
-
Lephantome92
- Senior Member
- Posts: 443
- Joined: April 21st, 2008, 8:36 am
- Contact:
Son0fHobs : You do end up making other creases. After making step 60, imagine a step 60a where you have to reverse fold the two flaps down. This should lead to step 61. Hope this helps. If not, try step 36 of the alien by the same author foud here. It is essentially the same steps.
Lephantome92 : The link doesn't work for me either... Try this one : http://www.pajarita.org/usuarios/gilgad ... ilgado.pdf.
Lephantome92 : The link doesn't work for me either... Try this one : http://www.pajarita.org/usuarios/gilgad ... ilgado.pdf.
-
Lephantome92
- Senior Member
- Posts: 443
- Joined: April 21st, 2008, 8:36 am
- Contact: