http://www.josephwu.com/Files/GIF/sorc1.gif
Repeat steps 2-6 to see actually easy.
But something's wrong.
Can someone give me a series of pictures of these steps make?
Would be so grateful
Perry Bailey "Simple" Sorceror
Forum rules
READ: The Origami Forum Rules & Regulations
READ: The Origami Forum Rules & Regulations
-
OrigamixFreak
- Newbie
- Posts: 4
- Joined: March 26th, 2012, 11:05 am
Perry Bailey "Simple" Sorceror
I have problems with this model.
http://www.josephwu.com/Files/GIF/sorc1.gif
Repeat steps 2-6 to see actually easy.
But something's wrong.
Can someone give me a series of pictures of these steps make?
Would be so grateful
http://www.josephwu.com/Files/GIF/sorc1.gif
Repeat steps 2-6 to see actually easy.
But something's wrong.
Can someone give me a series of pictures of these steps make?
Would be so grateful
-
Baltorigamist
- Moderator
- Posts: 2376
- Joined: December 25th, 2011, 7:15 pm
- Location: Inside my twisted mind....
Re: Perry Bailey "Simple" Sorceror
I don't have time to take pictures right now, but steps 2-5 are as if you creased the waterbomb along one angle bisector and open-sunk it.
The sink in 6 is a bit trickier, though, because of the interior edges. Just precrease it from where the sink starts, open the model from inside as much as you can without separating the edges, and push the point in. One edge will be wrapped around another.
The sink in 6 is a bit trickier, though, because of the interior edges. Just precrease it from where the sink starts, open the model from inside as much as you can without separating the edges, and push the point in. One edge will be wrapped around another.