jason kus devil crane

origamifreak_1.6180339889 · November 22nd, 2009, 2:46 pm

hi everybody, im having trouble finding the reference points to this model
http://scripts.mit.edu/~jasonku/index.p ... evilcrane1
i was able to locate the reference points for the birdbase but nothing else. can someone please post a picture or something? thanks

topsu · Post by **topsu** » November 22nd, 2009, 6:15 pm

Not sure if it's exact, but this is what I found:

basically it gives you the reference for the line under the bird base, rest of the creases should be easy to find.

origamifreak_1.6180339889 · November 22nd, 2009, 9:52 pm

i already figured that much out but i do not belaive theres enough information to continue

chesslo · Post by **chesslo** » November 22nd, 2009, 10:56 pm

From what I see, there is enough to continue, where you stuck on?

origamimasterjared · November 23rd, 2009, 1:59 am

The square at the bottom right is 1/3 of the side.

Falcifer · Post by **Falcifer** » November 23rd, 2009, 9:25 am

origamimasterjared wrote:The square at the bottom right is 1/3 of the side.

It's close, but not exactly at 1/3.

Assuming the sides are 1 unit long, the square at the bottom right is 0.32 units from the right.

(3√2 - 2)/7 units to be exact

origamimasterjared · November 23rd, 2009, 10:16 am

Whoops, don't know how I was so far off. Guess that's what happens when I don't zoom in...

How about something like this?

Falcifer · Post by **Falcifer** » November 23rd, 2009, 11:00 am

origamimasterjared wrote:Whoops, don't know how I was so far off. Guess that's what happens when I don't zoom in...

How about something like this?

That looks like it works.

Here's another, for the same point. Click for a larger view

origamimasterjared · November 23rd, 2009, 11:25 am

Yeah, I found a couple other ways of getting that point. But the one I drew is the most likely, as it's a reference point Kamiya uses a lot! (So it would naturally come up and/or Jason would be inclined to use it)

legionzilla · Post by **legionzilla** » November 23rd, 2009, 1:48 pm

I used the one-third reference for mine. Though it was not exact, its good enough for me.

origamifreak_1.6180339889 · November 23rd, 2009, 8:59 pm

thanks, i folded it today in school with some notebook paper. the only problem i had with it was getting the front neck to be the right size. it came out a bit long. but other than that, it came out alright for notebook paper

OrigamiMagiro · Post by **OrigamiMagiro** » November 24th, 2009, 5:37 am

The reference points were fairly arbitrary. Use different reference points to get different proportions. I just picked a set I liked.

For this creasepattern, the point is not how to get the reference point, but where it is. A little trig yields below, and you can find your reference points using whatever method you like. I suggest reading Lang's treatise on reference points for methods to progress from there...

http://www.langorigami.com/science/hha/ ... ctions.pdf

[img]http://jasonku.scripts.mit.edu/misc/dc.jpg[/img]